IBM IntelliStation Z Pro 6223 Installation Manual page 38

26
IntelliStation Z Pro Type 6223: Installation Guide
8. To install a drive in bay 2, complete the following steps:
a. Remove the large drive clip attached to the side of bay 2 of the drive cage
for bays 1, 2, and 3 (see the figure below). Slide the drive clip to the left to
disengage it from the drive cage; then, snap the drive clip into the screw
holes on the side of the drive.
b. If you are installing a 5.25-in. drive in bay 2, slide the drive into the drive
bay until it snaps in place. If you are installing a 3.5-in. drive in bay 2, you
must attach the 5.25-in. conversion kit, which you can order from IBM, to
the 3.5-in. drive.
c. Continue with step 10.
9. To install a drive in bay 3, use one of the following procedures:
Note: Only a 3.5-in. device can be installed in bay 3.
v If you are installing an external media device in bay 3, complete the
following steps:
a. Remove the small drive clip that is attached to the side of bay 3 of the
drive cage for bays 1, 2, and 3 (see the figure above). Slide the drive
clip to the left to disengage it from the drive cage; then, snap the drive
clip into the screw holes on the side of the drive.
b. Slide the drive into the drive bay until it snaps in place.
c. Continue with step 10.
v If you are installing a hard disk drive in bay 3, complete the following steps:
a. Push the drive into the drive bay from the rear of the drive cage; then,
use the two screws to attach the drive to the drive cage.
b. Continue with step 10.
Drive release tabs
Drive clip