Configuration - IBM 1000 VA LCD Installation And Maintenance Manual

Configuration

Only the available options are displayed.
User settings are not protected by default. You can enable the password through
the User Password setting.
The following table describes the options that you can change.
Table 8. Configuration settings
Description Available settings
Change language [English] [French] [German] [Spanish] [Japanese] [Simplified
Chinese] [Russian] [Korean] [Traditional Chinese]
User password [Enabled] [Disabled]
If Enabled, the default password is USER.
Note: If you enter an incorrect password, the message Wrong
Password is displayed. Press any button to return to the password
screen and retry the password.
Audible alarms [Enabled] [Disabled]
Note: If you disable audible alarms, it takes effect instantly and
remains disabled, even after a power cycle. This differs from the
mute feature, by which the horn is temporarily silenced when any
button is pressed but turns on again if a new alarm is triggered.
Set date and time Set Month, Day, Year, Hours, Minutes, and Seconds
Date: mm/dd/yyyy
Time: hh:mm:ss
Notes:
1. The date format is dependent on the language selection.
2. Time is a 24-hour clock.
3. If the uninterruptible power supply was shut down completely,
Control commands [Enabled] [Disabled]
from serial port
If Enabled, control commands are accepted through the serial
port, USB ports, or option card.
If Disabled, configuration and load control commands are
restricted to LCD only.
Output voltage [100V] [110V] [120V] [127V]
[220V] [230V] [240V]
Note: Numerical output voltage settings that are configured in
Standby mode take effect immediately. Any settings that are
configured outside of Standby mode take effect after the next
power off and restart.
Output frequency [50Hz] [60Hz] [Auto sensing]
Note: Numerical output frequency settings that are configured in
Standby mode take effect immediately. Auto sensing and any
settings that are configured outside of Standby mode take effect
after the next power off and restart. Selecting auto sensing
disables the battery start feature until after the next successful
startup on utility power.
24
1000 VA and 1500 VA LCD Tower UPS: Installation and Maintenance Guide
set the date and time.
Default setting
English
Disabled
Enabled
Date: 01/01/2010
Time: 12:00:00
Enabled
[120V] for 120 V model
[100V] for 100 V model
[230V] for 230 V model
Auto sensing
Note: The default auto
sensing runs once to set
the output frequency and
then is disabled.