IBM Rack Power Distribution Unit Installation And Maintenance Manual page 16

11. After you connect the power cords to properly wired and grounded dedicated
12. Route all the other power cables neatly, using the cable-management bracket if
6
IBM Distributed Power Interconnect Rack Power Distribution Unit:Installation and Maintenance Guide
power sources, you can turn on the Rack PDU circuit breakers; then, connect
other devices in the rack cabinet to the power outlets on the Rack PDUs.
installed, and secure the power cables with cable straps.
Note: To route a power cable through the cable-management bracket, route the
cable through an opening in the bracket and against an upper or lower tab on the
bracket, as shown below. Use cable straps as required.
Tab