Download Print this page

IBM Rack Power Distribution Unit Installation And Maintenance Manual page 10

Hide thumbs


Statement 8:
Statement 9:
WARNING: Handling the cord on this product or cords associated with accessories
sold with this product, will expose you to lead, a chemical known to the State of
California to cause cancer, and birth defects or other reproductive harm. Wash
hands after handling.
ADVERTENCIA: El contacto con el cable de este producto o con cables de
accesorios que se venden junto con este producto, pueden exponerle al plomo, un
elemento químico que en el estado de California de los Estados Unidos está
considerado como un causante de cancer y de defectos congénitos, además de otros
riesgos reproductivos. Lávese las manos después de usar el producto.
IBM Distributed Power Interconnect Rack Power Distribution Unit:Installation and Maintenance Guide
Plug power cords from devices in the rack cabinet into electrical
outlets that are located near the rack cabinet and are easily accessible.
Each rack cabinet might have more than one power cord. Be sure to
disconnect all power cords in the rack cabinet before servicing any
device in the rack cabinet.
Install an emergency-power-off switch if more than one power device
(power distribution unit or uninterruptible power supply) is installed in
the same rack cabinet.
Connect all devices installed in a rack cabinet to power devices
installed in the same rack cabinet. Do not plug a power cord from a
device installed in one rack cabinet into a power device installed in a
different rack cabinet.
Overloading a branch circuit is potentially a fire hazard and a shock
hazard under certain conditions. To avoid these hazards, ensure that your
system electrical requirements do not exceed branch circuit protection
requirements. Refer to the information that is provided with your device
for electrical specifications.