Hiniker 2752 Operator's Manual page 9

the lift frame to fall forward, possibly causing
personal injury or damage to plow components.
Retract Cylinder With Upper Lift Links
Rotate the stop plate up to contact the spacer
bushing on the lift cylinder bolt.
Rotate Stop Plate
Gently push back on the headlight bracket to
tilt the lift frame back as far as possible, then
release the bracket to allow the weight of the lift
frame to lock the stop plate in place.
Push Lift Frame Back
Swing the latch handle open until the latch
sliders are fully removed from the attachment
prongs.
DWG NO. 6000
Swing Handle To Remove Sliders
Lower the parking stand to the ground by remov-
ing the tab lock pin from stand index plate, then
swinging the stand to the ground with the lever.
DWG NO. 6004
Lower and Pin Parking Stand
Reinstall the pin in the index plate through the
hole in the lever to hold the stand in place.
DWG NO. 6005
Operating Procedures 7
DWG NO. 3856
DWG NO. 4201A
(Next Page)