Hiniker 2752 Operator's Manual page 22

20 Plow Assembly
17. Remove the plug mount plate kit from the
hardware bag in the parts box.
REF. PART
NO. NUMBER
1 25011037 Clamp
2 700-10904 Machine Screw #6-32 x 1
3 951-003-014 Lock Nut #6-32 Nylon Insert
4 950-004-076 Machine Screw #10-24 x 1 1/2
5 392-010-010 Lock Nut #10-24 Nylon Insert
6 950-004-033 Machine Screw #6-32 x 1/2
7 36716025 Nylon Lanyard 8"
8 367-001-011 Cable Tie 14"
9 25010278 Plug Mount Plate
10 36716002 Dust Cap
Fasten the power cable connector to the
clamp by inserting the #6 x 1 inch machine
screw through the small hole in the con-
nector, then through the center hole of the
clamp. Secure the screw with a #6 lock nut.
Fasten the clamp to the mount plate with
the two #10 x 1-1/2 inch machine screws
and #10 lock nuts supplied.
Mount the 10-pin circular connector to the
mount plate with four #6 x 1/2 inch screws
and lock nuts such that the tab on the con-
nector will be up, as shown.
Assemble the mount plate and connector
covers to the vehicle grill with plastic ties.
DWG NO. 3900
DESCRIPTION QTY.
18. Locate three blue connector splices in the
hardware bag in the plow's parts box.
Using a blue splice, crimp the single brown
wire from the underhood harness into the
vehicle's driver's side parking light wire.
Using a blue splice, crimp the single yellow
wire from the underhood harness into the
vehicle's driver's side turn signal wire.
1 Using a blue splice, crimp the single green
1
wire from the underhood harness into the
5
vehicle's curbside turn signal wire.
2
2
19. Select the proper headlight adapter for your
4
1
vehicle, specific instructions are included
4
with each kit.
1
2
The headlight adapter kit consists of two
identical adapters. Install the adapters ac-
cording to the instructions included with the
kit and connect to the 5-pin connectors of
the underhood wiring harness.
20. Secure all cables away from hot or moving
components with cable ties.
This completes the Electrical Installation.
21. At this point, the mount kit should be as-
sembled onto the truck.
Prongs from the truck mount kit should
be at a height that will slightly lift the plow
frame when attaching the plow. Prong re-
ceivers on the plow frame should be paral-
lel to the ground when attaching the plow.
Apply powered graphite on the truck prongs
to help the plow to slide on and off more
easily.
DWG NO. 4165