Hiniker 2752 Operator's Manual page 19

Refer to drawing 6502. Attach the ring ter-
minal of the solid red (or red-striped) wire
of the power cable assembly to the terminal
on the power unit at location 1.
Fasten the ring terminal of the solid black
wire of the power cable assembly, the ring
terminal on the black wire of the plow har-
ness and the ring terminal of the solenoid
ground harness to the terminal on the motor
at location 2.
Connect the three black wires of the ground
harness to solenoids S1, S2 and S3.
Connect the gray wire from the wiring har-
ness to solenoid S1. S1 extends the right
side of the plow to plow left.
Connect the tan wire from the wiring har-
ness to solenoid S2. S2 extends the left
side of the plow to plow right.
Connect the blue wire from the wiring har-
ness to solenoid S3. S3 lowers the plow.
Truck Battery On Passenger Side
Connect the RH headlamp to the wiring har-
ness end labeled "PSNGR SIDE" and the
LH headlamp to the end labeled "DRIVER
SIDE".
Ensure connections are fully mated for
proper sealing. There should be no gaps
between connector halves. Secure these
cables to the frame with plastic ties.
NOTE: Install the plow harness so that water does
not run down the wires and pool inside the "Y" con-
nection. Position the harness so that any trapped
water can easily drain away.
WARNING: Disconnect truck battery
before beginning electrical installa-
tion to avoid shock hazard.
8. The motor solenoid, underhood wiring har-
ness, power cable and joystick control box
are located in the parts box shipped with
the snowplow frame.
Plow Assembly 17
DWG NO. 6477