Hiniker 2752 Operator's Manual page 18

16 Plow Assembly
Connect the remaining two hoses to the fit-
tings from ports A and B at the back of the
power unit. Route both hoses ahead of the
lift frame tube before assembling the hose
from port A to the LH side angling cylinder
and the hose from port B to the RH side an-
gling cylinder.
The fitting in the LH side angling cylinder may
have to be adjusted slightly to route the hy-
draulic hose to best avoid interference with
the latch handle and the lift links. Use plastic
tie straps to secure all hydraulic hoses away
from lift link stops.
6. Before assembling the headlamp brackets
on the lift frame tube, scrape a small amount
of paint from the three holes in each bracket
and from the four holes in the frame tube to
provide a good electrical ground for the turn
signals and parking lights.
Mount the headlamp brackets to the lift
frame tube with four 3/8 inch x 2 inch
DWG NO. 6485
7.
NOTE: To prevent corrosion lightly coat all elec-
trical connections, ring and spade terminals with
dielectric grease prior to assembly.
DWG NO. 6312B
carriage bolts and flanged lock nuts from the
hardware bag in the parts box.
Remove the LH and RH headlamps from
their boxes and mount on the brackets with
hardware from the headlamp boxes.
Use plastic tie straps to band headlamp
cable above and below the brackets at the
locations shown to provide clearance for the
power unit cover later.
Refer to sections titled "System Check-Out"
and "Headlamp Aiming Procedure" in this
manual for aiming instructions.
Identify the plow power cable assembly
and plow wiring harness in the parts box. A
ground wire harness for the solenoids is in
the power unit box.
The power cable for the snowplow has two
cables with ring terminals on one end and
a two pin connector on the other and mea-
sures about 38" long.
The plow wiring harness has a 10-pin con-
nector on one end and the other end has
connectors labeled "DRIVER SIDE" and
"PSNGR SIDE" for the headlamps and four
loose wires with spade terminals.
The ground wire for the solenoid has one
wire 7 inches long and two wires 11 inches
long. There is a 1/4 inch ring terminal on the
common end and three spade receptacles
on the remaining ends.
DWG NO. 6502