Hiniker 2752 Operator's Manual page 21

11. Select an area near the drivers side fender
for the relays. Drill three 1/8" diameter holes
and secure the relays with #8 x 1/2 inch self-
tapping screws from the hardware bag in the
parts box.
12. Splice the red with white stripe wire to the
vehicle's switched 12 volt auxiliary electri-
cal circuit. This will prevent operation of the
plow without the vehicle key being on. This
wire controls the accessory relay that pow-
ers the control joystick and solenoids.
13. Connect the joystick control box to the 7-pin
connector inside the truck cab. Secure the
box at a safe location in the cab with the strip
of hook and loop fastener.
WARNING: Ensure that the motor so-
lenoid and associated wiring will clear
any hood lift/spring mechanisms be-
fore installation.
IMPORTANT: Do not over tighten nuts on the
motor solenoid terminals. Over-tightening causes
premature solenoid failure. Refer to torque speci-
fications on the solenoid.
14. Select an area within 16 inches of the vehi-
cle battery for the motor solenoid. Using the
solenoid as a template, mark then drill two
3/16" diameter holes and fasten the solenoid
with two 1/4 inch x 1/2 inch long self tapping
screws from the hardware bag in the parts
box.
Connect the Black wire to one of the small
posts on the solenoid, connect the Orange
wire to the remaining small post, polarity is
not important.
15. Safely route the 10-pin circular connector
through the grill of the vehicle to a location
that will be easily accessible with the plow
attached.
16. Refer to drawing 6479. Install the underhood
power cable by first connecting the Black ca-
ble and the two Black wires from the harness
to the minus (-) post of the vehicle's battery.
Connect the Red (or Red striped) cable to
the motor solenoid. Route the power cable
to the grill near the 10-pin connector.
Connect the Red fused wire from the har-
ness and the 24 inch Red cable to the plus
(+) terminal of the battery or battery access
post. Connect the other end of the 24 inch
Red cable to the motor solenoid.
Plow Assembly 19
DWG NO. 6479