Connect Phone - AT&T Home Base User Manual

STEP 1: Set Up Your Device
B Turn on Your Device
1 . Plug the power cord into an electrical wall outlet.
2. Connect the other end of the power cord into the Power Input port on
the back of your AT&T Home Base.
3. Press and hold down the round On/Off button for 3 full seconds until the
power light stays steady green.
Check the Wireless Signal
C
Wait a few seconds for the signal strength light to turn on, while your device
connects to the cellular network.
Confirm signal strength
light is green for optimal
performance. Yellow
indicates a moderate
signal and may
be sufficient.
NOTE: If you do not see a green light, you may want to choose another
location in your home, such as near a window or outside wall.
6
(continued)
On/Off
Hold 3 seconds
Getting Started
STEP 2: Connect Your Phone
A Unplug your Phone from the Wall Jack
The AT&T Home Base is not used with your home phone wall jack.
NOTE: If you have a cordless phone, keep it plugged into a power outlet.
Connect your Phone to the Device
B
Plug your phone into the "Phone 1" port on the AT&T Home Base, using your
existing phone cable or the included phone cable.
NOTE: Do not plug the device into your home phone wall jack.
Signal
Strength
Getting Started 7