AT&T Wireless Home Phone and Internet Quick Start

Quick Start

AT&T Wireless Home Phone
and Internet
AT&T Home Base
STEP 1: Set Up Your Device
A Install the Back-up Battery
1. Remove the bottom of the device by pushing the entire cover in the
direction of the arrow.
Ports
2. Insert the back-up battery.
Battery
3. Replace the cover.
Getting to Know Your Device
Power
Voicemail
Information
(See "AT&T Home Base Manager"
on reverse)
™
For more information, refer to your User Guide, visit att.com/devicehowto, or call AT&T Support at
1-800-331-0500.
B Turn on Your Device
1 . Plug the power cord into an electrical wall outlet.
2. C onnect the other end of the power cord into the Power Input port on the
back of your AT&T Home Base.
3. P ress and hold down the round On/Off button for 3 full seconds until the
power light stays steady green.
Signal Strength
Wi-Fi
WPS Ethernet On/Off
(See "User
Guide")
Telephone Power
Ports Input
On/Off
Hold 3 seconds
Before You Begin
The AT&T Home Base uses the AT&T cellular network and DOES NOT use
your home phone wall jacks.
Your device should be located:
• W here you have a strong signal from a cell tower, typically near a window
or outside wall. Signal strength may vary in different parts of your home.
• N ear an electrical wall outlet.
• I n the general area where you'll be using your home phone, computer, or
Wi-Fi enabled devices.
C Check the Wireless Signal
W ait a few seconds for the signal strength light to turn on, while
your device connects to the cellular network.
Confirm signal strength light is green for optimal performance.
Yellow indicates a moderate signal and may be sufficient.
Signal
Strength