HP ProCurve 2810 Series Access Security Manual page 259

Configuring and Monitoring Port Security
Port Security Command Options and Operation
attempt to convert the port back to static mode with the same authorized
address(es), the Inconsistent value message appears because the port
already has the address(es) in its "Authorized" list.
If you are adding a device (MAC address) to a port on which the Authorized
Addresses list is already full (as controlled by the port's current Address Limit
setting), then you must increase the Address Limit in order to add the device,
even if you want to replace one device with another. Using the CLI, you can
simultaneously increase the limit and add the MAC address with a single
command. For example, suppose port A1 allows one authorized device and
already has a device listed:
Figure 9-6. Example of Port Security on Port A1 with an Address Limit of "1"
To add a second authorized device to port A1, execute a port-security command
for port A1 that raises the address limit to 2 and specifies the additional
device's MAC address. For example:
ProCurve(config)# port-security a1 mac-address 0c0090-
456456 address-limit 2
Removing a Device From the "Authorized" List for a Port Configured
for Learn-Mode Static. This command option removes unwanted devices
(MAC addresses) from the Authorized Addresses list. (An Authorized Address
list is available for each port for which Learn Mode is currently set to "Static".
See the "MAC Address" entry in the table on 9-8.)
C a u t i o n
The address-limit setting controls how many MAC addresses are allowed in
the Authorized Addresses list for a given port. If you remove a MAC address
without also reducing the address limit by 1, the port may later detect and
accept the same or another MAC address that you do not want in the Autho-
rized Address list. Thus, if you use the CLI to remove a MAC address that is
no longer authorized, you should first reduce the Address Limit (address-limit)
integer by 1, as shown in the next example. This prevents the possibility of the
same device or another device on the network from automatically being
9-15