Table of Contents
Advertisement
An inventory collects data about the network resources that the technology pack monitors. After you install
an SNMP technology pack, you must create an inventory profile using the
initiate a discovery by executing the inventory profile using the
Running the initial inventory against SNMP objects is an intricate task and unfortunately beyond the scope
of this configuration appendix. For instructions on using the
profile and the
Inventory Tool
Guide.
12. Edit pack-specific UBA parameters, based on the following Netcool/Proviso platforms:
— 443 and higher
— Pre-443
443 and Higher
In this release of Netcool/Proviso, you were instructed to modify the technology pack-specific UBA
parameters when you installed the Cisco IP Telephony Technology Pack, using the Topology Editor. If you
did not modify the UBA parameters with site-specific values or you want to make additional edits, you can
do so now. Otherwise, you can go to the next step.
See the Installing Technology Packs chapter of the Netcool/Proviso Installation Guide for more information.
Pre-443
The Cisco IP Telephony Technology Pack requires specific UBA parameters that are not in the
The DataChannel installer creates a
(
/opt/datachannel/conf
called
voip_cisco_ipt_sample_dc.cfg
The best practice on adding these pack-specific parameters to the
— Edit the pack-specific UBA parameters in the template file with site-specific values.
— Manually add them to the
To edit the pack-specific UBA parameters in the template file with site-specific values, follow these steps:
12-a. On the DataChannel server, change your working directory to the
DATA_CHANNEL_HOME/scripts
DATA_CHANNEL_HOME
cd DATA_CHANNEL_HOME/scripts
12-b. Make a backup copy of the
following command:
cp voip_cisco_ipt_sample_dc.cfg voip_cisco_ipt_sample_dc.cfg.ORIG
12-c. In a text editor, open the
12-d. Edit the pack-specific UBA parameters according to the instructions provided in
.
Reference
Note:
The cross reference link to Appendix B
limitation.
12-e. When you are satisfied with your edits, write (but do not quit) the
voip_cisco_ipt_sample_dc.cfg
Important:
Editing the dc.cfg file is a non-trivial task and prone to error. Take your time and check your work
carefully.
Netcool/Proviso Cisco IP Telephony Technology Pack User's Guide, Version 4.3-W
to execute the inventory profile, see the Netcool/Proviso DataMart Configuration
file in the
DATA_CHANNEL_HOME/conf
dc.cfg
, by default). These pack-specific parameters were delivered in a template file
.
file.
dc.cfg
directory by entering the following command, replacing
with the DataChannel home directory (
voip_cisco_ipt_sample_dc.cfg
voip_cisco_ipt_sample_dc.cfg
Template File Reference does not work due to a formatting
,
template file.
Appendix A: Configuration
Inventory Tool Wizard
.
Inventory Tool
to create an inventory
Inventory Tool Wizard
file is to:
dc.cfg
/opt/datachannel
template file, by entering the
template file for editing.
Appendix B, Template File
and then
file.
dc.cfg
directory
, by default):
449
Advertisement
Table of Contents
