Beam iridium SatDOCK 9555 Quick Start Manual

4. MIC / Audio Connections
Connecting Microphone:
• The microphone should be connected to the HFI and then recessed
up the door pillar or similar to a head height location close to the
driver
• Care should be taken to avoid wind or high noise environments
• Avoid crimping or damaging the microphone cable during installation
Installing Speaker:
• Mount the speaker underneath the seat or other location that
avoids the speaker facing the microphone
• If feedback occurs upon testing try redirecting the speaker or
locate in another location.
MIC
MIC
Speaker
5. Inserting 9555 Handset
1. Remove rubber grommet on back of 9555 antenna connection
2. Ensure 9555 handset is turned off
3. Ensure there is no foreign object in the cradle
4. Place the 9555 in the cradle with the base in first
5. The base connector should line up with the base of the 9555
6. Gently push the face of the 9555 into the SatDOCK
7. The 9555 should click into the locked position
1. Place 9555 on 2. Push 9555
the base of the
Phone into the
cradle SatDOCK
6. Ejecting 9555 Handset
To remove the
9555 handset
from the cradle
FIRMLY press
the "Eject" button
located on the
top of the cradle
(see diagram).
7. Using SatDOCK 9555
• After turning key/Acc on, the SatDOCK will beep upon power up
• Wait for phone to power up and register
• To call, dial the number on the 9555 keypad
• Audio/Mic will automatically route through the HFI unit
• The volume of the call can be increased using the 9555 volume
• The call can be muted using the Mute button on the SatDOCK
• When Mute is ON the Red LED will illuminate
• Incoming calls will ring with a fixed tone via the speaker
• (See User Manual to adjust the ring volume)
Speaker
• Incoming calls answered by pressing green key on 9555
8. Optional Handset Modes
Intelligent User Handset: (Fully featured)
• The Beam RST970 Intelligent Handset can be used with
SatDOCK using the RJ45 connector on the HFI unit. The
SatDOCK must be restarted to use this handset.
Compact Privacy Handset: (Side-Jack Mic / Audio Mode)
• The compact handset can be simply used with the SatDOCK
by connecting to the Side-Jack of the 9555 where a portable
Click
hands-free connect.
NOTE: To activate the Side-Jack mode, depress the Mute button
for 1.5 seconds, the LED will flash Orange indicating the Side-
Jack Mode is active. Press again to return to normal hands free
mode.
3. Ensure to
'click' to lock
position
1. Firmly press 2. Release the
'Eject' Button phone
www.beamcommunications.com
info@beamcommunications.com
TEL: +61 3 8588 4500
FAX: +61 3 9560 9055

QUICK START GUIDE

iridium SatDOCK 9555
Suitable for the
Iridium 9555 Portable Satellite Telephone
Beam Communications Pty Ltd