Troubleshooting; Problem Solving; Reading The Indicators; Indicator Status During An Error/Warning - Epson EH-TW9100W User Manual

Troubleshooting

Problem Solving

Reading the Indicators

You can check the status of the projector from the flashing and lit
the control panel.
Refer to the following table to check the projector's status and how to remedy problems shown by the
indicators.

Indicator status during an error/warning

Indicators
Replace Lamp
(orange)
High Temp Warning
(orange)
Internal Error
(red)
Fan Error
Sensor Error
(red)
Status
It is time to replace your lamp. Replace the lamp with a new lamp
as soon as possible.
The lamp may explode if you continue to use it in this status.
You can continue projecting. If the temperature rises too high
again, projection stops automatically.
•
If the projector is installed next to a wall, make sure there is at
least 20 cm between the wall and the projector's exhaust vent.
•
If the air filter is clogged, clean it. s
The projector has malfunctioned.
Remove the power plug from the electrical outlet, and contact
your local dealer or the nearest Epson repair center.
Projector Contact List
79
, (operation indicators),
t
: Lit
Remedy
p.94
s
p.90
and on
o m
: Flashing : Off
Epson
s