Table of Contents
Advertisement
Appendix
Troubleshooting
Reading the indicators
You can check the status of this unit using the
indicators on the top panel.
Check each condition in the following table and follow
the steps to remedy the problem.
* If all indicators are not lit, the power cable is not
connected correctly or the unit is not powered.
When
lights on red
Internal failure
Red
Wait for approximately 1 minute and 30 seconds.
Then, disconnect and reconnect the power cable.
Red
If the indicator status does not change when
Red
is pressed and the power turned on...
Fan related error/Sensor error
Red
Red
High temperature error
Red
(overheating)
The lamp turns off automatically and
projection stops. Wait for approximately 5
Red
minutes. When the Power indicator color
changes to orange, check for the 3 points
shown at right.
58
Error
Disconnect the power cable from the electrical
If the error continues
outlet and contact your dealer.
Wait for approximately 1 minute and 30
seconds. Then, disconnect the power cable
from the electrical outlet and contact your local
dealer or the nearest address provided in the
Inquiries.
• Move this unit away
from the wall by at
least 20 cm.
• Clean the air filter.
s
p. 62
• When using this unit
at high altitudes, that
is 1500 m or more
above sea level, set
"High Altitude Mode"
s
to "On".
p. 56
: lit
: flashing
s
p. 74
If the indicator status
does not change when
is pressed and the
power turned on...
: off
Advertisement
Table of Contents
