Selling Point Descriptions - Hitachi C 10RA2 Technical And Service Manual

4-1. Selling Point Descriptions

(1) Wide table
An extension wing is standard on this machine to give
the table a width of 864 mm (34"). This provides a
wide ripping surface of up to 360 mm (14-5/32") to the
right of the saw blade and up to 400 mm (15-3/4") to
the left of the saw blade when using the rip fence.
(2) High cutting capacity with 255 mm (10") TCT blade
A 255 mm (10") TCT saw blade is standard on this
machine.
150 mm (5-29/32")
Cutting direction
Surface roughness (max.)
Direction of probe
(3) Good work efficiency with electric brake
When the switch is turned off after a cutting operation, the electric brake will stop the saw blade (in about 3 -- - 5
seconds). Efficient operation is assured when removing the cut material.
(4) Equipped with a high-power 1,940 W (2.6 hp) motor
The high-power motor facilitates fast cutting operations.
Hitachi C 10RA2
Saw marks
Fig. 1
Fig. 2
60 x 150 mm material
Maker/
Model name
HITACHI
C 10RA2
Maker/
Model name
HITACHI
C 10RA2
Cutting material: Douglas fir
Percentage of water content: 13 to 16 %
Right-angle cutting in 17 seconds.
Using the roughness meter, the roughness
(irregularities in the surface shown in Fig. 2) was
measured by moving the probe in the direction of the
arrow as shown in Fig. 1.
15 seconds
--- 2 ---
Table 1
Max. ripping width
To right of saw To left of saw
blade
360
(14-5/32")
Table 2
Cutting depth of
saw blade
45˚
90˚
Bevel
11 --- 63
0 --- 76
(7/16" ---
(0 --- 3")
2-1/2")
Table 3
Maker/Model name Max. output
HITACHI C 10RA2 1,940 (2.6 hp)
(Unit: mm)
blade
400
(15-3/4")
(Unit: mm)
Cut section
Max. surface
roughness
44 µm
(Unit: W)