Assembly - Hitachi C 10RA2 Technical And Service Manual

8-2. Assembly

WARNING: To avoid an accident or personal injury, always confirm that the switch is turned OFF and
the power plug has been disconnected from the receptacle before assembly of this tool.
8-2-1. Assembly of the Handle Bar
Wheel
Handle bar
8-2-2. Installing of the Rip Fence
CAUTION: The rip fence must be aligned parallel to the saw blade to minimize kickback.
Grip
Width
body
8-2-3. Assembly of the Miter Gauge
Miter gauge groove
Sheet bar
Miter gauge
Fig. 7
Supprot
Rear rail
Front rail
Fig. 8
Fig. 9
The handle allows faster turning of the wheel.
When properly assembled, it will rotate freely but with only a
small amount of play,
(1) Tighten the screw of the handle until it hits against the
wheel.
(2) Securely tighten the handle bar nut with a wrench.
The rip fence can be conveniently used to cut a workpiece
into different pieces of precise width or into parallel pieces.
It can be mounted on either the right or left side of the table.
(1) Tighten the screw of the grip.
(2) Catch the hook of the support in the bottom part of the
rear rail.
(3) Lower the rip fence in the arrow direction, and fit the part
of the width body and support to the groove of the front
and rear rail.
(4) Confirm that the rip fence is moved right and left and it
moves smoothly.
The miter gauge is convenient for cutting long or angular
pieces which are difficult to work on with the rip fence. It
can be mounted on either the right or left side of the table.
Align the sheet bar of miter gauge with the miter gauge
groove and slide it in the direction indicated by the arrow
through the front of the table.
--- 10 ---