Disassembly Method; Main Board - JVC HX-Z1 Service Manual

Compact component system

Hide thumbs Also See for HX-Z1:

Table of Contents

HX-Z1

2.1.1 Removing the metal cover

(See Fig.1 ~ 3)

• Remove the six screws A on the back of the body.

• Remove the screw B on each side of the body.

• Remove the metal cover from the body by lifting the rear part

of the cover.

CAUTION:

Do not break the front panel tab fitted to the metal cover.

2.1.2 Removing the CD changer mechanism assembly

(See Fig.4, 5)

• Prior to performing the following procedure, remove the metal

cover.

(1) Disconnect the card wire from connector CN651 on the

CD servo control board on the right bottom of the CD

changer mechanism assembly.

(2) Remove the four screws C attaching the CD changer

mechanism assembly on top of the body.

(3) Remove the CD changer mechanism assembly while lift-

ing the rear part.

CAUTION:

Do not damage the CD fitting when removing the CD changer

mechanism assembly.

Fig.1

Fig.2

SECTION 2

Disassembly method

Fig.3

Fig.4

Fig.5

Table of Contents