Table of Contents
Advertisement
Disassembly method
Removing the metal cover
1.
Remove the three screws A attaching the metal
cover on the back of the body.
2.
Remove the six screws B attaching the metal cover
on the both sides of the body.
3.
Remove the metal cover from the body by lifting the
rear part of the cover.
ONE POINT
How to eject the CD tray
Although it will end if the OPEN/CLOSE
button is pushed when a power supply can
be taken, when that is not right, CD tray will
be opened manually.
Turn the loading pulley gear at the bottom of
the CD changer unit as shown in Fig.2 and
draw the CD tray toward the front.
Removing the CD Tray fitting
Prior to performing the following procedure, eject the
CD tray.
1.
After drawing the lower part of the tray fitting toward
the front, remove the five claws. Then, while moving
the tray fitting upward, remove it.
Removing the CD changer unit
Prior to performing the following procedure, remove
the metal cover.
1.
Remove the card wire attached to CD changer unit
on the adhesion tape.
2.
Disconnect the card wire from the connector CW107
on the CD servo board.
3.
Disconnect the harness from the connector RCW6
on the main board and CW105 on the CD servo
board.
4.
Remove the two screws C attaching the CD changer
unit to the rear panel.
5.
Remove the two screws D attaching the CD changer
unit to the both side of front panel assembly.
6.
Draw the CD changer unit upward from behind while
pulling the rear panel outward.
(See Fig.1)
(see fig.2)
(See Fig. 3)
CD tray fitting
(See Fig.4 to 7)
Adhesion tape
Metal cover
B
(both sides)
Fig.1
Loading pulley gear
(See <CD changer unit>fig.1)
Fig.2
Joint
Claw
Fig.3
Card wire
CD changer unit
Fig.4
MX-GT700
A
1-5
Hide quick links:
Advertisement
Table of Contents
