Mechanism; Cdchanger Mechanism Type Vc3 Section - JVC HX-Z1 Service Manual

3.1 CDchanger Mechanism Type VC3 Section

3.1.1 Removing the CD Servo control board
(See Fig.1)
(1) Remove the metal cover.
(2) Remove the CD changer mechanism assembly.
(3) From bottom side the CD changer mechanism assem-
bly,remove the four screws A retaining the CD servo con-
trol board.
(4) Absorb the four soldered positions a of the right and left
motors with a soldering absorber.
(5) Pull out the earth wire on the CD changer mechanism as-
sembly.
(6) Disconnect the connector CN854 on the CD servo control
board.
(7) Disconnect the card wire CN601 and the connector
CN801 on the CD servo control board.
SECTION 3

MECHANISM

HX-Z1
Fig.1
15