Product Information
The AMX AXP-CPI16 16 Channel Custom Panel Interface Board (FIG. 1) simplifies the process of
creating custom control panels for Axcess systems. Providing contact closure inputs and feedback
outputs for up to 16 buttons, the miniature PC board contains a 20-pin header for ribbon cable
installation or for direct mounting to a printed circuit board.
AXlink
Connector
Device
DIP Switch
AXlink Status LED
-Pin Header P2
onnect this side to the ribbon cable
FIG. 1
AXP-CPI16 components
Specifications
The following table lists product specifications for the AXP-CPI16.
AXP-CPI16 Specifications
Dimensions (HWD)
Power
Inputs
Outputs
AXlink Connector
Headers
AXP-CPI16 16-Channel Custom Panel Interface
Pin 1
2.75" x 1.75" x 0.062" (69.90 mm x 44.50 mm x 1.557 mm)
• Input voltage: 12 VDC (nominal)
• Current draw: 25mA
16 closure inputs with a common ground (GND)
16 open-collector outputs, acting as switch to ground, up to 100 mA DC each for:
• Board is not to supply more than 750 mA of +12V total.
• Small incandescent lamps
• LED indicators - with series resistor (1K for 12 VDC)
• Relays - with DC coil
A 4-pin (male) connector attached to a four-wire cable which sends control data from the
Axcess CardFrame to the AXP-CPI16.
Two 20-pin headers included for ribbon cables (up to 100 feet each) or for mounting
directly to a PC board.
Product Information
20-Pin Header P3
Connect this side to the ribbon cable
Pin 1
Connect this side to
the PC board
1