Meyer Sound MM-4XP Operating Instructions Manual page 2

DECLARATION OF CONFORMITY ACCORDING TO ISO/IEC GUIDE 22 AND EN 45014
Manufacturer's Name:
Meyer Sound Laboratories Inc.
Manufacturer's Address:
2832 San Pablo Avenue
Berkeley, CA 94702-2204, USA
Declares that the products
Product Name: MM-4XP
MPS-488
MPS-488
Product Options: All
Conforms to the following Product Specifications
Safety: EN 60065: 2002
IEC 60065: 2005
UL 60065: 2006
EMC: EN 55103-1: 1997 emission (1)
EN 55103-2: 1997 immunity (2)
This device complies with EN 55103-1 & -2. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
© 2007
Meyer Sound. All rights reserved.
MM-4XP Miniature Loudspeaker Operating Instructions
The contents of this manual are furnished for informational purposes only, are subject to change without notice, and should not be con-
strued as a commitment by Meyer Sound Laboratories Inc. Meyer Sound assumes no responsibility or liability for any errors or inaccura-
cies that may appear in this manual. Except as permitted by applicable copyright law, no part of this publication may be reproduced,
stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, recording or otherwise, without prior writ-
ten permission from Meyer Sound.
Compass, Galileo, and all alpha-numeric designations for Meyer Sound products and accessories are trademarks of Meyer Sound. Meyer
Sound, the Meyer Sound wave logo, and SIM are registered trademarks of Meyer Sound Laboratories Inc. (Reg. U.S. Pat. & Tm. Off.). All
third-party trademarks mentioned herein are the property of their respective trademark holders.
Printed in the U.S.A.
Part Number: 05.163.005.01 A
ii
P
E
Supplementary Information
The product herewith complies with the requirements of the Low
Voltage Directive 73/23/EEC and the EMC Directive 89/336/EEC.
Office of Quality Manager
Berkeley, California USA
May 1, 2007
European Contact: Your local Meyer Sound dealer or Meyer Sound
Germany, GmbH. Carl Zeiss Strasse 13, 56751 Polch, Germany.
Telephone: 49.2654.9600.58 Fax: 49.2654.9600.59
Environmental specifications for Meyer Sound Electronics products
Operating Temperature
Non operating Temperature <–40° C or >+75° C
Humidity
Operating Altitude
Non operating Altitude
Shock
Vibration
Made by Meyer Sound Laboratories
Berkeley, California USA
European Office:
Meyer Sound Lab. GmbH
Carl Zeiss Strasse 13
56751 Polch, Germany
Pending
0° C to +45° C
to 95% at 35° C
to 4600 m (15,000 ft)
to 6300 m (25,000 ft)
30 g 11 msec half-sine on
each of 6 sides
10 Hz to 55 Hz (0.010 m peak-
to-peak excursion)
C
US
Pending
Pending