See Fig. - JVC TH-S11 Service Manual

3.2.7 Removing the DVD loading switch board

(See Fig.10.)

(1) From the bottom side of the DVD mechanism assembly, re-
move the wires from the soldered sections n on the DVD
loading switch board.
(2) Remove the screw G attaching the DVD loading switch
board.
(3) Lift the DVD loading switch board while pressing the claw
p of the DVD mechanism assembly in the direction of the
arrow and remove it from the section q.
Reference:
Pass the wires through the section r after attaching the DVD
loading switch board to the DVD mechanism assembly.
3.2.8 Removing the loading motor
(See Figs.10 to 14)
(1) From the bottom side of the DVD mechanism assembly, re-
move the wires from the soldered section n on the DVD
loading switch board. (See Fig.10.)
(2) Remove the screw H attaching the tray assembly. (See
Fig.10.)
(3) From the right side of the DVD mechanism assembly, push
the slide cam and pull the tray assembly out of the DVD
mechanism assembly in the direction of the arrow. (See
Fig.11.)
(4) From the top side of the DVD mechanism assembly, re-
move the two screws J attaching the clamper base. (See
Fig.12.)
(5) Lift the clamper base in an upward direction to remove it
from the engagement sections s and remove the engage-
ment sections t in the direction of the arrow. (See Fig.12.)
(6) Remove the two screws K attaching the tray assembly and
take out the tray assembly from the DVD mechanism as-
sembly. (See Fig.13.)
(7) Remove the belt from the motor pulley. (See Fig.14.)
Note:
Take care not to attach grease on the belt.
(8) Remove the two screws M attaching the loading motor to
the DVD mechanism assembly and take out the loading
motor from the bottom side of the DVD mechanism assem-
bly. (See Fig.14.)
Reference:
Pass the wires through the section r after attaching the loading
motor to the DVD mechanism assembly. (See Fig.10.)
DVD loading switch board
Wires
p
n
G
q
r
DVD mechanism assembly
Fig.10
DVD mechanism assembly
Tray assembly
Slide cam
Fig.11
Clamper base
J
s
s
J
DVD mechanism assembly
Fig.12
H
Tray assembly
t
t
(No.MB413)1-21