Dvd Pickup. (See Fig - JVC TH-S55 Service Manual

3.3.2 Removing the DVD module board
(See Figs.2 and 3)
• Remove the traverse mechanism assembly.
(1) From the side of the traverse mechanism assembly, solder
the short land sections a on the DVD pickup. (See Fig.2.)
(2) From the bottom side of the traverse mechanism assem-
bly, release the lock of the connector
module board in the direction of the arrow and disconnect
the card wire. (See Fig.3.)
Caution:
• Solder the short land sections a on the DVD pickup be-
fore disconnecting the card wire from the connector
CN101 on the DVD module board. If the card wire is
disconnected without attaching solder, the DVD pick-
up may be destroyed by static electricity. (See Figs.2
and 3.)
• When attaching the DVD module board, be sure to re-
move solders from the short land sections a after con-
necting the card wire to the connector
DVD module board. (See Figs.2 and 3.)
(3) Disconnect the card wire from the connector
DVD module board. (See Fig.3.)
(4) Remove the two screws B attaching the DVD module
board. (See Fig.3.)
(5) Remove the DVD module board from the engagement sec-
tion b in an upward and remove the engagement section c
in the direction of the arrow. (See Fig.3.)
CN101 on the DVD
CN101 on the
CN201 on the
a
Traverse mechanism assembly
Fig.2
Card wire
B
CN101
c
DVD module board
Traverse mechanism assembly
Fig.3
DVD pickup
Card wire
CN201
b
B
(No.MB365)1-15