The Arrow And Remove The Thrust Spring. (See Fig - JVC TH-C9 Service Manual

3.3.10 Removing the feed motor
(See Figs.18 and 19)
• Remove the tray assemblies and DVD traverse mechanism
assembly.
(1) From the top side of the DVD traverse mechanism assem-
bly, remove the screw K attaching the feed bracket and re-
move the feed bracket from the sections t. (See Fig.18.)
(2) Release the claw u of the thrust spring in the direction of

the arrow and remove the thrust spring. (See Fig.18.)

(3) Remove the screw shaft from the section v and remove it
in the direction of the arrow. (See Fig.19.)
(4) Remove the middle gear. (See Fig.19.)
(5) Remove the screw L attaching the feed motor to the C.TM
chassis. (See Fig.19.)
(6) Remove the wires from the soldered sections w on the
spindle motor board. (See Fig.19.)
(7) Take out the feed motor from the motor base.
Reference:
After attaching the feed motor, pass the wires through the sec-
tions x on the C.TM chassis as before. (See Fig.19.)
Thrust spring
Fig.18
Spindle motor board
Middle gear
v
Screw shaft
w
x
Fig.19
Feed bracket
K
t
Thrust spring
u
C.TM chassis
L
(No.MB427)1-23