Hiniker 9850 Operator's Manual page 25

NOTE: A new hydraulic lift cylinder may leak a
small amount of oil until packings become satu-
rated and produce a good seal. If leakage is ex-
cessive, or if leaking continues after initial cycling,
tighten the cylinder packing nut in 1/8-turn incre-
ments until leaking stops.
22. Check that the plow blade is level on the
ground with the wings in the scoop position
and the plow on the ground.
Level the plow in the scoop position by loos-
ening the hardware through the front of the
pushframe and through the diagonal braces
to allow the plow to settle to the ground. Re-
tighten the hardware once the plow is level.
23. Fasten the power unit cover assembly to
the lift frame bracket with two 1/4 inch x
3/4 inch screws, flat washers and lock nuts
from the hardware bag in the parts box.
Tighten the lock nuts so that the assembly
is secure, yet the cover hinges freely.
24. Assemble side markers on the ends of the
DWG. NO. 5996
DWG. NO. 6310
When the cover is closed, rods from the
latch handles should extend behind the
light brackets to hold the cover in place.
moldboard with 5/16 inch bolts, flat washers
and lock nuts.
V-Plow Assembly 23
DWG. NO. 6014A
DWG. NO. 6006