Hiniker 9850 Operator's Manual page 18

16 V-Plow Assembly
Connect port C on the power unit to the rod
end of the LH wing cylinder using the long
hose routed through the hose loop.
Connect port D on the power unit to the butt
end of the LH wing cylinder, using one of
the short hoses.
Connect port E on the power unit to the lift
cylinder.
Use a plastic tie strap to band the four wing
cylinder hoses together as they hang verti-
cally. Also band the two rod end hoses to-
gether just ahead of the hose loop.
6. Before assembling the headlamp brackets on
the lift frame tube, scrape a small amount of
paint from the three holes in each bracket and
the four holes in the frame tube to provide a
good electrical ground for the turn signals and
parking lights.
DWG. NO. 6456A
7.
DWG. NO. 5997A
Mount the headlamp brackets to the lift frame
tube with four 3/8 inch x 2 inch carriage bolts
and flanged lock nuts from the hardware bag
in the parts box.
Remove the LH and RH headlamps from their
boxes and mount on the brackets with hard-
ware from the headlamp boxes.
Use plastic tie straps to band headlamp ca-
bles above and below the brackets at the
locations shown to provide clearance for the
power unit cover rods later.
Refer to sections titled "System Check-Out"
and "Headlamp Aiming Procedure" in this
manual for aiming instructions.
Identify the power cable assembly and wiring
harness for the plow power unit in the electri-
cal components parts box. A ground harness
for solenoids on the power unit is in the power
unit box.
The power cable assembly has two cables
with ring terminals on one end and a two pin
connector on the other, and measures about
38 inches long.
The wiring harness has a ten pin connector
and a three pin connector on one end and the
other end has connectors labeled "DRIVER
SIDE" and "PSNGR SIDE" for the headlamps,
and six loose wires with spade receptacles
and one wire with a ring terminal.
The ground wire harness has a ring terminal
and six spade receptacles on two wires.
DWG. NO. 6012B