Hiniker 9850 Operator's Manual page 20

18 V-Plow Assembly
Truck Battery On Passenger Side
WARNING: Disconnect truck battery
before beginning electrical installa-
tion to avoid shock hazard.
The motor solenoid, underhood wiring harness,
power cable and joystick control box are locat-
ed in the parts box shipped with the snowplow
frame.
NOTE: Fill electrical connectors with dielectric
grease, and lightly coat ring and spade termi-
nals before installation to prevent corrosion.
8. Refer to drawing 6474. Lay the harness in
it's approximate position for final assembly
with the 7-pin and 3-pin circular connectors
near the drivers side firewall, the 10-pin
and 3-pin connectors just left of center near
the grill, the relays near the drivers side in-
ner fender and the 5-pin headlight connec-
tors at the respective headlights.
9. Determine the location of the vehicle bat-
tery. If the battery is located on the right
(passenger) side or if there are two batter-
ies configured as a 12 volt system then pro-
ceed to step 10. If the battery is located on
the left side of the vehicle then the wiring
harness will need to be modified.
DWG. NO. 6474