Hiniker 9850 Operator's Manual page 24

22 V-Plow Assembly
20. At this point, assemble the mount kit on the
truck as described in the instructions sup-
plied with each kit.
Prongs from the truck mount kit should
be at a height that will slightly lift the plow
frame when attaching the plow.
Apply powdered graphite on the prongs to
help the plow slide on and off more easily.
Prong receivers on the plow frame must be
parallel to the ground before attaching the
plow.
Attach the plow onto the truck by driving the
truck prongs into the receivers on the plow
frame. Pull the latch handle into the frame
clevis to move sliders through the notches
in the prongs and receivers. Pin the handle
in the clevis with its klik pin.
21.
DWG. NO. 6003
DWG. NO. 5995
Raise the parking stand to its highest posi-
tion and repin.
Connect the three electrical cables from
the plow to their corresponding receptacles
on the truck.
Select Hiniker Cold Flow Hydraulic Oil or
an equivalent oil that meets military speci-
fication 5606, for plowing in extremely cold
temperatures.
Pour hydraulic oil into the power unit reser-
voir until the oil level reaches the fill level.
Raise and lower the plow, and cycle the wings
to purge any air trapped in the system. Check
the oil level with the plow on the ground and
the wings retracted.
Add oil to the fill line, if necessary, but do not
overfill the reservoir.
DWG. NO. 5232
DWG. NO. 6453A