SANYANG INDUSTRY CO. SYM Service Manual page 144

14. STEERING/FRONT WHEEL/FRONT SHOCK ABSORBER SYM
Remove the left axle ring and dust seal.
Speedometer gear dust seal
DISC BRAKE
Remove the dust seal on the right side of
speedometer gear.
Remove the bearing with the inner type
Bearing spacer
bearing remover.
Take out the bearing spacer and then Bearing
remove the other bearing.
Bearing
Tool:
Inner type bearing remover
Dust seal
Wheel side collar
Bearing Inspection
Clearance
Turn the inner race of bearing with fingers.
Clearance
The bearing should be turn smoothly. Also
check if the outer collar is tightly connected
to the wheel hub.
If the bearing do not turn smoothly, or if they
are too loose in the races, or damaged, then,
remove and replace the bearings with new
ones.
Caution
The bearing must be replaced in pair.
Installation
Install the bearing according to the reverse
procedure of removal.
Apply some grease into the bearing seat of
the wheel hub.
Install the left bearing onto the seat.
Install the bearing spacer and then install
the right bearing onto the seat.
14-6