Master Cylinder Installation - SANYANG INDUSTRY CO. SYM Service Manual

13. BRAKE
INSTALLATION
Place the master cylinder onto handlebar,
and install the split ring and bolts. The
"UP" mark on the split ring should face
upward.
Align the split ring on the master cylinder
seat with the alignment point on the
handlebar.
Tighten the upper bolt of the seat to
specified torque value, and then tighten
lower bolt to the same specified torque
value.
Install the brake lever, and connect leads to
brake lamp switch.
Connect brake hoses with 2 new washes.
Tighten the brake hose bolt to the specified
torque value.
Torque value: 3.5 kgf-m
Make sure the hose is installed correctly.
CAUTION
Improper routing may damage leads,
hoses or pipes.
CAUTION
Kink of brake leads, hose or pipe may
reduce brake performance.
Add specified brake fluid and bleed the
system and conduct the air-bleeding job for
the system.
13-10
master cylinder
split ring
"UP" mark
sealing washer
hose bolt
brake hose
SYM
mounting seat
bolts x 2