Battery Removal - IBM TotalStorage 201 User Reference Manual

CAUTION:
When replacing the lithium battery, use only IBM Part Number 10L6432 or an
equivalent type battery recommended by the manufacturer. If your system has a
module containing a lithium battery, replace it only with the same module type made
by the same manufacturer. The battery contains lithium and can explode if not
properly used, handled, or disposed of.
Do not:
v Throw or immerse into water.
v Heat to more than 100 C (212 F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Note: For translations of the safety notice, refer to the multilingual Safety Information on the
Documentation CD that came with the appliance.
To replace the battery:
1. Review the information in the section "Before you begin" in the hardware
2. Turn off the appliance and peripheral devices and disconnect all external cables
3. Remove the battery:
Figure 3. Battery removal
4. Insert the new battery:
60
NAS 200 User's Reference
installation guide that came with this appliance, and any special handling and
installation instructions supplied with the replacement battery.
and power cords; then, remove the appliance cover.
a. Use one finger to lift the battery clip over the battery.
b. Use one finger to slightly slide the battery from its socket. The spring
mechanism behind the battery will push the battery out toward you as you
slide it from the socket.
c. Use your thumb and index finger to pull the battery from under the battery
clip.
d. Ensure that the battery clip is touching the base of the battery socket by
pressing gently on the clip.
a. Tilt the battery so that you can insert it into the socket, under the battery
clip.
b. As you slide it under the battery clip, press the battery down into the socket.