Alert-On Lan¬ Test; Asset Id¬ Test; Test Results - IBM NETVISTA 2251 Hardware Maintenance Manual

Alert-On LAN¬ test
The Alert On LAN test does the following:
v Determines if Alert On LAN is supported on the system.
v Checks the revision ID register.
v Verifies the EEPROM checksum.
v Validates that a software alert can be sent.
Asset ID¬ test
The Asset ID test does the following:
v Determines if Asset ID is supported on the system.
v Verifies the EEPROM areas.
v Performs an antenna detection test.

Test results

Diagnostic test results will produce the following error code format:
v Function Code:
v Failure Type:
v DeviceID:
v Date:
12
Hardware Maintenance Manual
v Memory Test-Quick
The quick memory test will take about 20 seconds per MB of memory and
will detect solid (stuck) memory failures only.
Notes:
Either level of memory testing can be performed on all memory or a single SIMM or
DIMM socket.
Only sockets containing a SIMM or DIMM can be selected for testing. Unpopulated sockets
are noted by ........ beside the test description.
Function Failure Type
Code
Represents the feature or function within the PC.
Represents the type of error encountered.
Contains the component's unit-ID which corresponds to either a fixed disk
drive, removable media drive, serial or parallel port, processor, specific SIMM or
DIMM, or a device on the PCI bus.
Contains the date on which the diagnostic test was run. The date is retrieved
from CMOS and displayed using the YYYYMMDD format.
DeviceID Date ChkDigits Text