Replacing The Cover - IBM NETVISTA 2251 Hardware Maintenance Manual

Replacing the cover

To replace the cover, do the following:
1. Ensure that all components have been reassembled correctly and that no tools
2. Clear any cables that might impede the replacement of the cover.
3. Position the cover over the chassis so that the front edge is approximately one
4. Lower the cover down over the chassis so that the rail guides engage the rails.
5. Slide the cover forward. You might need to lift the front of the cover slightly to
6. Insert the three thumbscrews into the holes in the cover and the chassis and
28
Hardware Maintenance Manual
or loose screws are left inside your computer.
inch away from the front bezel.
align it properly.
tighten.