Gear Shift, Drive - Ghost E-HYBRID TRAIL 9000 Operating Manual

15.1

Gear shift, drive

Malfunction
Gears do not change or do not
change smoothly
Drive blocks during or after gear
shifting
Unusual noise such as cracking,
loud grinding and/or banging
Irregular resistance during the
pedal movements
70
Possible cause(s)
Shift lever not actuated correctly
Shift mechanism maladjusted
· In the case of steep
inclinations, excessive
pressure on the pedal
· and/or pedalling movement
too slow
Chain jamming
Drive/gearing components
damaged
Drive/gearing components
damaged
GHOST EPAC
Remedy
Actuate the lever again
Contact your specialist bicycle
dealer.
Repeat the gear shifting
procedure on flat terrain.
Changing gear while stationary:
· Lift the rear wheel.
· Turn the crank in the drive
direction until the desired gear
is engaged.
· Leave the EPAC where it is.
· Turn off the standby mode in
accordance with section 10.3,
Switching off the electric drive
· Actuate the gear lever in the
opposite direction.
· Lift the rear wheel.
· If this is possible without
force:
turn the crank in the opposite
direction to the drive.
NOTE:
Under no circumstances should
you apply force if the crank
cannot be easily turned .
You should contact your
specialist workshop for bicycles
immediately.
Contact your specialist bicycle
dealer immediately.