Station Preset Memory; Auto Memory Entry - Kenwood KDC-4009 Instruction Manual

14
Tuner features (See page 8)
Station Preset Memory
Store the frequency of a station. You can then recall that sta-
tion with a single touch of a button.
1 Select the band/station that you want to have stored.
2 Press the button (#1-6) that you want to use for the station, for
at least two seconds.
The button number blinks once in the display to indicate that
the data has been stored.
Recalling a Preset Station:
Press the preset station button (#1-6) for the desired station.
The number of the recalled station is displayed.
You can store six stations in each of the FM1, FM2, FM3, and
AM bands.
Auto Memory Entry
You can automatically store all the receivable frequencies in
the band currently being listened to, and then recall them with
the touch of a button later. This function is especially useful
when you are travelling and do not know what stations are
available. Up to six frequencies can be stored this way.
1 Select the band for which you want to store stations.
2 Press the AME button for at least two seconds to start auto
memory entry.
The numbers of the preset station buttons are shown in order.
When all the stations in a certain band are stored in the preset
memory, the auto memory entry stops. The tuner then plays
the last station received.
Recalling a Preset Station:
Press the preset station button (#1-6) for the desired station.
The number of the recalled station is displayed.
Clean Reception System Circuit (CRSC)
Temporarily have reception switched from stereo to mono to
reduce multi-path noise when listening to the FM station.
The factory default for this function is ON.
Turning CRSC On/Off:
Press the CRSC button for at least one second to turn the
function on/off. "CRSC ON" is displayed when CRSC is on.
Strong electrical frelds (such as from power lines) may cause
unstable sound quality when CRSC is turned on. In such a situa-
tion, turn it off.
Function of Remote (See page 10)
Direct Access Tuning
When you already know the frequency of the station that you
want to listen to, you can enter it directly for quick access.
(Function of remote control}
1 Select the band by pressing the FM or AM button.
2 Press the DIRECT button.
In the display, "----" blinks for 10 seconds.
If you make no input in the 10-second period, direct access
tuning is automatically cancelled.
3 Enter the frequency of the desired station whilst the display is
blinking.
If you want to listen to an FM station at 92.1 MHz, for exam-
ple, press 0, 9, 2, and 1.
If you want to listen to an AM station at 810 kHz, for example,
press O, 8, 1, and 0.
* When a frequency which cannot be received is input, this fre-
quency Is not verified and operation returns to the original fre-
quency input mode,
* FM frequencies can only be input in 0.1 MHz steps, and not in
0.01 steps.
Cancelling Direct Access Tuning:
Press the DIRECT button again.