Canon G2000 Instruction Manual page 9

Charging and attaching the battery pack
3
POWER
Your battery pack was partially charged before it left the factory. It should have
enough power for you to check that your camera is working properly. However,
you must charge the battery pack fully if you want it to power the camera for
more than a few minutes.
1. Set the Program selector to OFF before you charge the battery pack.
2. Open the terminal cover from its top and connect the power adapter
to the camera's DC IN terminal.
3. Attach the battery pack to the camera.
• Align the triangle on the battery pack with the line on the camera. Slide the
battery in the direction of the arrow until it clicks into place.
4. Plug the adapter into a mains outlet.
• The charge indicator flashes to show that charging is in progress. Single
flashes mean that the battery pack is less than 50% charged. Double flashes
mean that it is between 50% and 75% charged. Triple flashes mean that it is
more than 75% charged. The indicator glows steadily when the battery pack
is fully charged.
5. When charging is complete, disconnect the power adapter.
6. Detach the battery pack after use.
• Press and hold the BATTERY RELEASE button while you slide the battery
off the camera.
• Always turn the camera off before removing the power source.
Note:
• You can find detailed notes for using the batteries in the "Notes on Using the
Batteries" on p. 52. These notes include charging and recording times and how to
install the backup battery.
4
2
E
6
9