User-Definable Font Set - IBM 31x Installation And Service Manual

11-9-2005
Ps
0 (X'30') Reset display mode. Characters written after this command are reset
5 (X'35)' Blinking mode. Characters written after this command blink ON and
7 (X'37') Reverse mode. Characters written after this command are reversed.

User-definable font set

Purpose:
Pf (font size)
Pn (font number) 1 ∼ 32 (X'31' ∼ X'33', X'32') Pf=1, 2
Pc (registration
address)
Pd...Pd
Available registration address can be established as follows:
1. Font size 5x7
2. Font size 8x16
3. Font size 16x16
Mode
to normal display mode.
OFF every 0.3 seconds.
1B 5C 3F 4C 57 Pf 3B Pn 3B Pc 3B Pd...Pd
This command specifies a user-definable font set. The control bytes
embedded in the command sequence (represented by Pf, Pn, and Pc in the
preceding command format), change the font characteristics. Pd...Pd
represents the font data bytes.
1 (X'31'): 5x7 dots (ANK)
2 (X'32'): 8x16 dots
3 (X'33'): 16x16 dots
1 ∼ 16 (X'31' ∼ X'31', X'36') Pf=3
2 hex digits Pf=1, 2
4 hex digits (Pf=3)
2 hex digits x 7 Pf=1
2 hex digits x 16 Pf=2
2 hex digits x 2 x 16 Pf=3
Note: All data is stored into RAM. You must issue this command every
time you switch ON the power.
At the all language
X'20'--X'FF'
English
X'01'--X'FF' (except X'08', X'0A', X'OD', X'1B')
Japanese
X'20'--X'7F', X'A0'--X'DF'
Korean, Simplified Chinese and Traditional Chinese
X'20'~ X'A0'
Japanese JIS X 0208-1990 (Font selection X'1B', X'53', X'31')
X'8140'--X'81FF', X'8240'--X'84FF' (Positions X'8200'--X'823F' are not
available.)
X'8840'--X'88FF', X'8940'--X'9FFF' (Positions X'8900'--X'893F' are not available.)
X'E040'--X'E0FF', X'E140'--X'EAFF' (Positions X'E100'--X'E13F' are not
available.)
Korean KS C 5601-1992 (Font selection X'1B', X'53', X'32')
X'A1A0'--X'A1FF', X'A2A0'--X'ACFF' (Positions X'8200'--X'829F' are not
Input/output device commands
Appendix A. Input/output device commands
A-13