Table of Contents
Advertisement
Safety precautions
I ....
WARNING
I
To prevent injury or fire, take the following
precautions:
Mountinq and wirinq this product requires skills and
experience. For safety's sake, leave the mountinq and
wiring work to professionals.
• When extending the ignition, battery, or ground
wires, make sure to use automotive-grade wires or
other wires with the range of 1 Ii
mm
1
(/\WC 6) to
21 mm
2
(f\WG 4) to plevr::nt wire deteriordtion and
damage to the wire coating.
To
prevent a short circuit, never put or leave any
metallic objects (such as coins or metal tools) inside
the unit.
If the unit starts to emit smoke or suallCJe smells,
turn orl the power immediately and consult your
Kenwood dealer.
Do not touch the unit during use because the
surface of the unit becomes hot and may cause
burns if touched.
I ....
CAUTION
I
To prevent damage to the machine, take the
following precautions:
Be sure the unit is connected to
a
12V DC power
supply with
a
negative ground connection.
Do not open the top or bottom covers of the unit.
Do not install the unit in a spot exposed to direct
sunlight or excessive heat
01
humidity. Also avoid
places with too much dust or the possibility of water
splashing.
• When replacing a fuse, only use a new one with the
prescribed rating. Using a fuse with the wrong rating
may cause your unit to malfunctior1.
• To prevent a short circuit \:vhen replacing a fuse, first
disconnect the wiring harness.
FCC WARNING
This equipment may generate or use radio
frequency energy. Changes or modifications to this
equipmeilt may cause harmful interference unless
the rnodifications are expressly approved in the
instruction manual. The user could lose the authority
to operate this equipment if an unauthorized change
or modification is made.
FCC NOTE
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC fiules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment may cause harmful inter'ference to radio
communications, if it is not installed and used in
accordance with the instructions. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct
the interference by one
or
more of the follovving
measures:
• lieorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on
a
circuit different from that
to
which the receiver is
connected.
• Consult the dealer or an experienced radio!lV
technician for help.
I
NOTE
I
This Class
B
digital apparatus complies with Canadian
ICES-003.
I
NOTE
I
• If you experience problems during instal!ation,
consult your Kenwood dealer.
If the unit does not seem to be working right
consult your Kenwood dealer.
2
English
CE
Declaration of Conformity with
regard to the EMC Directive
2004/108/EC
Manufacturer:
Kenwood
Corporation
2967-3 Ishikawa-machi, Ilachioji-shi,
Tokyo,
192-8525
Japan
EU Representative's:
Kenwood Electronics Europe BV
.A.msterclamse,:veg
37, 1422 AC
UITHOOHN,
The
Netherlands
Advertisement
Table of Contents
