Table of Contents
Advertisement
Troubleshootin9_G_u_i_de
_
What might appear to be a malfunction in your unit may just be the result of slight misoperation or
miswiring. Before calling service, first check the following table for possible problems.
• Check connections by referrinq to
<Protection function>.
• rieplace the fuse and use lower
volume.
• After check the speaker cord and
fixing the cause of the short replace
the fuse.
• The speaker cord is shorted.
• Volume is too high.
No sound.
. Input (or output) cables are
• Connect the input (or output) cables.
(No sound from one side.)
disconnected.
(Blown fuse.)
. Protection circuit may be activated.
The output level is too
small (or too larqe).
• The input sensitivity adjusting control
is not set to the correct position.
• Adjust the control correctly referring
to <Controls>.
The sound quality is bad.
(The sound is distorted.)
• The speakers wire are connected with
wrong EB/E3polarity.
• A speaker wire is pinched by a screw
in the car body.
• The switches may be set improperly.
• Connect them properly checking the
EB/E3 of the terminals and wires well.
• Connect the speaker wire again so
that it is not pinched by anything.
• Set switches properly by referring to
<Svstem examoles>.
The Remote Controller
does not function.
• The Her'note Cable is disconnected.
• Connect the Heniote Cable securely
and correctly.
12
English
Advertisement
Table of Contents
