Table of Contents
Advertisement
Once you have selected the function step, press the switch once
more and hold it. The LED will flash and the siren will chirp to con-
firm the selected functional step. Do not release the Program switch.
Step
Function
1
Auto Learn Standard Configuration* (default)
The auto learn configuration will automatically setup the remotes button configuration.
Note: Due to the Supercode protocol, you cannot change the configuration.
2
Delete remotes: This feature will erase all remotes from the memory of the security
system. This is useful in cases when a customer's remote is lost or stolen.
Note:: This will not reset the programmed features of the security system or reset the
Virtual Tach setting.
3
Reset Features: This resets features all of the security system to the factory default set-
tings. Note: This feature does not delete the remotes from the security system or reset
the Virtual Tach setting.
4
Virtual Tach Reset: Deletes all previously learned values for Virtual Tach, and on the next
remote start sequence the unit will begin virtual tach initialization.
Note: The "Zap" feature on the Bitwriter will not reset the Virtual tach setting.
© 2008 Directed Electronics—all rights reserved
3 . Choose
Program switch
desired function step listed in the following table.
4. Transmit . While holding the Valet/Program switch, press
the
button on the remote control. The unit will chirp
to confirm that the code has been successfully pro
grammed. It is not possible to teach a remote control but
ton to the system more than once.
5 . Release . Once the code is learned, the Valet/Program
switch can be released.
Within 10 seconds, press and release the
.
corresponding to the number of the
Hide quick links:
Advertisement
Table of Contents
