Viper Responder LE 5701 Installation Manual page 32

Security and remote start

Hide thumbs Also See for Responder LE 5701:

Table of Contents

H2/6 LIGHT BLUE (-) 200mA 2nd unlock output

This wire produces a (-) 200mA output for progressive locks in which the driver

door unlocks first and the remaining locks will unlock with a second press of the

unlock button on the remote.

Note: This feature will need to be programmed "On" to function correctly (see

System Feature Menu #1, feature 8)

H2/7 GRAY/BLACK (-) Diesel wait-to-start input

Connect this wire to the wire in the vehicle that sends the signal to turn on

the WAIT-TO-START bulb in the dashboard. In most diesels the wire is negative

(ground turns on the bulb) and the GRAY/BLACK wire can be directly connected

to the wire in the vehicle. If the vehicle uses a positive wire (12V to turn on the

bulb) a relay must be used to change the polarity.

Note: The system has a programmable onboard timer (See Feature menu#3, fea-

ture 9) so it is not mandatory to connect to the wait-to-start wire in the ve-

hicle.

Note: A 1-amp diode must be installed in line on the factory wire between the

wait-to-start indicator and the ECM. (See the following diagram for details.)

Table of Contents

Show Quick Links

Table of Contents