Auxiliary Harness (H2) - Viper Responder LE 5701 Installation Manual

Auxiliary harness (H2)

H2/1 LIGHT GREEN/BLACK (-) Factory alarm Disarm
This wire sends a negative pulse every time the remote start is activated , chan-
nel 2 is activated (programmable on/off) or when the doors are unlocked with the
remote. This can be used to pulse the disarm wire of the vehicle's factory anti-
theft device. Use a relay to send a (-) or (+) pulse to the disarm wire as shown
in the following diagrams.
Relay for Negative (-) Disarm Wire
H2/2 GREEN/WHITE (-) Factory alarm Arm
This wire sends a negative pulse every time the remote start shuts down or when
the doors are locked with the remote. This can be used to pulse the arm wire of
the vehicle's factory anti-theft device. Use a relay to send a (-) or (+) pulse to
the arm wire.
H2/3 WHITE/VIOLET 200 mA (-) programmable Aux 1 output
This wire provides 200 mA programmable output whenever the transmitter but-
tons controlling Aux 1 channel is pressed. (See descriptions for Aux 3)
Warning! Never use this wire to drive anything but a relay or a low-cur-
rent input! This transistorized output can only supply 200 mA. Connecting
directly to a solenoid, motor, or other high-current device will cause the
module to fail.
30
Relay for Positive (+) Disarm Wire
© 2008 Directed Electronics—all rights reserved