Loading And Unloading The Milk Car - Lionel 13150 Hudson Steam Freight Owner's Manual

Operating and servicing your train set

Loading and unloading the Milk Car

L oad your Milk Car with cans, then watch the figure unload them at the press of a button!
This car operates best at 10-12 volts (AC).
1. Load the cans into the hatch in the roof. The top of the cans must be toward the center of
the car as you load them. Refer to Figure 17.
2. Position the Milk Car in front of the platform when you are ready to unload. The sliding
contacts on the trucks of the Milk Car must be on the Remote-Control Track section.
3. Press UNLOAD on the track controller. Each time this button is pressed, the doors of the Milk
Car will open and the figure will push a can onto the platform.
4. Adjust your track voltage until the man unloads the cans without knocking them over.
Be sure to completely unload the cans before you take the Milk Car off of the track. If the
Note!
car is turned upside-down and shaken, a can may occasionally become jammed inside the
chute. Refer to the next section to correct this problem.
Figure 17. Loading the cans
35