Directed Electronics 591XV Installation Manual page 38

1-9 CHANNEL 2:
In the delayed validity default setting the Channel 2 output will output a negative (-) signal after the
button is pressed for more than 1.5 seconds and will continue until the button is released.
The latched output selection will output a negative signal as soon as the
continue until the button is pressed again.
The latched/reset with ignition output selection operates just like the latched output but will reset or stop
when the ignition is turned on.
The 30-second timed output selection will latch the Channel 2 output on for 30 seconds when the remote
button is pressed or until the button is pressed again within the 30 seconds.
1-10 FACTORY ALARM DISARM (FAD) WITH CHANNEL TWO ON/OFF: Any time Channel 2 is activated from the
remote transmitter the factory disarm output will pulse to disarm the vehicle's factory anti-theft device. This
option can be programmed off if desired.
1-11 SECURITY FEATURES ON/OFF: When On the security features (starter kill and panic) will activate if the
ignition key is turned On while the doors are locked. When Off the security features (starter kill and panic) will
not activate if the ignition key is turned On while the doors are locked.
1-12 CODE-HOPPING ON/OFF: The system features Code-Hopping as an option. To use Code-Hopping technol-
ogy, this feature must be programmed On.
1-13 CHANNEL 4: This output can be programmed to produce a validity output that will stay active as long as
the transmitter button assigned to that channel is pressed, a latched output, a latched output reset with igni-
tion, or a 30-second timed output.
38
button is pressed and will
© 2003 Directed Electronics, Inc. Vista, CA