Emerson CF788AP00 Owner's Manual page 8

How to Put Your Ceiling Fan Together
7. Carefully turn partially assembled fan upside down
and place in styrofoam form carton, in preparation
for final installation.
8. Remove the hanger ball by loosening the setscrew
in the hanger ball until the ball falls freely down the
downrod (Figure 6). Remove the pin from the
downrod, then remove the hanger ball. Retain the
pin and hanger ball for reinstallation in Step 9.
9. Separate, untwist and unkink the two 80" motor
leads. Route the motor lead wires through the
downrod. Remove the upper setscrew from the
motor coupling. Align the clevis pin holes in the
downrod with the holes in the motor coupling.
Install the clevis pin and secure with the hairpin clip
(Figure 7). The clevis pin must go through the
holes in the motor coupling and the holes in the
downrod. Be sure to push the straight leg of the
hairpin clip through the hole near the end of the
clevis pin until the curved portion of the hairpin clip
snaps around the clevis pin. The hairpin clip must
be properly installed to prevent the clevis pin from
working loose. Pull on the downrod to make sure
the clevis pin is properly installed. Reinstall the
upper setscrew in the motor coupling. Check that
the lower setscrew is tightened securely (Figure 7).
NOTE: The setscrews must be properly installed
as described above, or fan wobble could result.
WARNING
!
It is critical that the clevis pin in the motor coupling
is properly installed and the setscrews securely
tightened. Failure to verify that the pin and setscrews
are properly installed could result in the fan falling.
10. Remove and retain the three #8-32 x 12mm
screws from the upper motor housing.
11. Make sure the grommet is properly installed in the
coupling cover, then slide the coupling cover on
the downrod until it rests on the motor housing.
Place the ceiling cover over the downrod. Be sure
that the ceiling cover and the coupling cover are
both oriented correctly (Figure 8). Secure the
coupling cover by reinstalling the three previous
removed #8-32 x 12mm screws.
HANGER
BALL
DOWNROD
Figure 6
MOTOR
COUPLING
SETSCREW
HAIRPIN
CLEVIS PIN
CLIP
CLEVIS
PIN
UPPER
SETSCREW
Figure 7
RUBBER GROMMET
MOTOR COUPLING
COVER
Figure 8
8
(continued)
PIN
SETSCREW
DOWNROD
CLEVIS
PIN
HAIRPIN
CLIP
CEILING
COVER
DOWNROD
COUPLING
COVER
SCREW (3)
ETL Model No.: CF788