Emerson CF788AP00 Owner's Manual page 7

How to Put Your Ceiling Fan Together
NOTE: Take care not to scratch fan housing when
installing blades.
3. Loosely attach one blade/flange assembly to the
motor hub by securing the two 1/4-20 x 14mm
captive pan head screws. Make sure the screws
are NOT tightened (Figure 3). Repeat this
procedure for other four blade assemblies.
! WARNING
To reduce the risk of personal injury, do not bend the
blade flange when installing the blade flanges,
balancing the blades or cleaning the fan. Do not
insert foreign objects in between rotating fan blades.
4. The blade flanges have an interlocking feature that
must be fully engaged before tightening the screw.
Make sure all the flanges are properly engaged
and then tighten the flange screws. If one of the
flanges does not seat properly on the motor hub,
loosen the adjacent flange screws, re-engage and
reseat the flanges, then tighten the screws again.
5. Remove and retain the three switch housing
mounting screws (Figure 4) from the switch
housing plate. Tuck the blue and white fan wire
carefully under the switch housing cover as shown
in Figure 4.
WARNING
!
To avoid possible fire or shock, do not pinch wires
between the switch cup assembly and the switch
cup plate.
6. Position the switch housing assembly on the
switch housing plate and align the holes in
the switch housing assembly with the holes in the
plate. Secure the switch housing assembly by
installing the three #8-32 x 12mm flat head screws
(supplied) (Figure 5).
MOTOR HUB
MOTOR HUB
NOTCHED AREA
1/4-20 x 14mm CAPTIVE
PAN HEAD SCREW (2 per
blade/flange assembly)
Figure 3
#8-32 x 12mm FLAT
HEAD SCREW (3)
Figure 4
#8-32 x 12mm FLAT
Figure 5
HEAD SCREW (3)
7
(continued)
BLADE/FLANGE
ASSEMBLY
SWITCH
HOUSING
ASSEMBLY
SWITCH
HOUSING
ASSEMBLY
ETL Model No.: CF788