Exmark Lazer Z Operator's Manual page 48

Hide thumbs Also See for Lazer Z:
Table of Contents

Advertisement

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
POTENTIAL HAZARD
♦ Engine must be running and drive wheels must be
turning so motion control adjustment can be performed.
WHAT CAN HAPPEN
♦ Contact with moving parts or hot surfaces may cause
personal injury.
HOW TO AVOID THE HAZARD
♦ Keep fingers, hands, and clothing clear of rotating
components and hot surfaces.
POTENTIAL HAZARD
♦ Raising the mower deck for service or maintenance
relying solely on mechanical or hydraulic jacks could be
dangerous.
WHAT CAN HAPPEN
♦ The mechanical or hydraulic jacks may not be enough
support or may malfunction allowing the unit to fall,
which could cause injury.
HOW TO AVOID THE HAZARD
♦ DO NOT rely solely on mechanical or hydraulic jacks for
support. Use adequate jack stands or equivalent
support.
a)
This adjustment must be made with the drive wheels turning. First raise the
frame and block up so that drive wheels can rotate freely.
b)
For all units with a standard seat: Remove the electrical connection from the
seat safety switch, located directly to the left of the seat switch assembly
beside the hydraulic oil reservoir.
For all units with a suspension seat: Disconnect the electrical connection
between the seat wiring harness and the lead coming from the main wiring
harness.
Temporarily install a jumper wire across the terminals in the connector of
the wiring harness.
c)
Run the unit at least 5 minutes with the drive levers at full forward speed to
bring hydraulic system oil up to operating temperature.
d)
Tilt seat forward.
e)
Loosen lock nuts from the ball joints at each end of the LH pump control
linkage. (See Figure 15).
www.mymowerparts.com
WARNING
CAUTION
- 43 -

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents