Exmark Lazer Z Operator's Manual page 46

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
5.2.9
5.2.10
5.2.11
3/16" (4.8 mm) to
1/4" (6.4 mm)
BRAKE ADJUSTMENT
Brake Adjustment.
a) Check for brake link 2.75" (7.0 cm) measurement as described in section 5.2.8.
b) Engage brake lever (lever up).
c) Measure the distance between the trunion roller and the rod collar.
Measurement should be 3/16" (4.8 mm) to 1/4" (6.4 mm). See Figure 11.
d) If adjustment is necessary, loosen the nut directly below the yoke. Turn the
bottom nut (below washer) until the correct measurement is obtained (See
Figure 11) turn nut clockwise to lengthen the gap (screws rod into yoke) and
turn counter-clockwise to shorten the gap (screws rod out of yoke). Tighten
nut against yoke and check opposite side of unit, repeat if necessary.
Adjust Throttle Lever Tension.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Tension in throttle lever can be adjusted by adjusting the tightness of the
lever pivot bolt, which is located under the console (See Figure 12).
THROTTLE TENSION
Electric Clutch Adjustment:
For All units except 25 HP Kohler units with 52" decks:
Units have Warner clutches and no adjustment is necessary.
For 25 HP Kohler units with 52" decks:
Determine the brand of clutch installed on your unit. Ogura clutches can be identified
by 3 bolts with springs. See Figure 13. Warner clutches do not have these bolts.
No adjustment necessary for Warner clutches.
For Ogura clutches proceed with the following steps:
a) Stop engine and remove key.
b) Engage parking brake.
www.mymowerparts.com
2.75"
(7.0 cm)
FIGURE 11
FIGURE 12
- 41 -